21
REPLACING PARTS
Before performing any maintenance operations, disconnect the appliance from the gas supply
and electricity network.
To replace parts such as knobs and burners, just remove them from the seats without
disassembling any part of the cooker.
To replace the oven bulb, just unscrew the protection cap that projects out inside
the oven. (Fig.13)
Fig. 13
WARNING: Before replacing the bulb, disconnect the appliance from the electric
power supply.
WARNING: The power cord supplied with the appliance is connected to the appliance with an
X type connection (in compliance with standards AS/NZS 60335-1, AS/NZS 60335-2-6 and
subsequent amendments) for which it can be installed without the use of special tools, with
the same type of cord as the one installed.
If the power cord becomes worn or damaged, replace it based on the
information reported in table 2.
WARNING: If the power cord is replaced, the installer shall ensure that the ground cable is
longer than the phase cables and also should comply with the warnings regarding the electric
connection.
