DRP 393 MPEG-4 Receiver/Decoder
Rev. L
www.blankom-digital.de
Page 13 (36)
Input-DVB-S/S2 (Option)
If the input source DVB-S/S2 is selected, you will go to the following configuration menu, where you can
configure the parameters required for DVB-S/DVB-S2. Click
Set
to transfer the configured data to the
device. In this way the SAT-ZF DVB-S/S2 signal is selected as the input signal. ASI and IP Input are
disabled.
The lock-in range of the input frequency is +5 MHz while the retaining range is ±12 MHz. The symbol rate
must be precisely specified. The lock-in range of the symbol rate is
≤
± 100 ksps. By pre-selecting the DVB-
S modes DVB-S or DVB-S2 the tuning procedure of the DRP 393 is accelerated. However the usual mode of
operation is AUTOMATIC.
The menu items 'LNB Voltage' and 'LNB 22 kHz Tone' are only displayed for the 75 Ohm variant and can be
configured accordingly.
The SCPC mode should be enabled if a narrow-band transport stream (< approx. 5 Msps) has to be received
and if there are several narrow-band transport stream on the transponder at the same time. By entering the
transport stream ID (SCPC TSID) it is ensured that the DRP 393 tunes on the selected transport stream. The
TSID must be entered in hexa-decimal format
.
