DRP 393 MPEG-4 Receiver/Decoder
Page 14 (36)
www.blankom-digital.de
Rev. L
IP Input (option):
The input source “IP” is accessible if this option is activated. The configuration of the IP Frontend is given
below.
Standard data protocol is UDP. RTP or proMPEG is optionally available. RTP enables fault detection during
transmission. ProMPEG includes fault protection that can correct transmission faults but needs additional
band width. The selected data protocol must correspond to the IP source protocol! In the same manner the
IP address and the port channel of the source must match. Multicast is possible by selecting the
corresponding IP addresses. Addresses in the range 224.0.0.0 to 239.255.255.255 are reserved for Multicast
transfer (one source, multiple recipients).
Service Filtering
Service filtering allows the filtering of services out of the transportstream. All DVB tables are adapted
according to the selection .
Service Filter mode:
Off:
No filtering function, all services are passed through.
Drop mode:
The selected services are filtered out , all other services are passed through If a new
service is in the transport stream this service will be passed through.
Pass mode:
The selected services are passed through, all other services are filtered out . If a new service
is in the transport stream this service will be filtered out.