DRP 393 MPEG-4 Receiver/Decoder
Page 2 (36)
www.blankom-digital.de
Rev. L
Important Notes!
This manual is for use by qualified personnel only. Handling this device or system requires special
electrotechnical knowledge. To reduce the risk of electrical shock or damage to the equipment, do not
perform any servicing other than the installation and operating instructions contained in this manual unless
you are qualified to do so. This device operates in the given voltage and frequency range without requiring
manual adjustment.
Special symbols that might appear on the equipment:
This symbol indicates that there are dangerous live parts
within the equipment, which are not insulated. Do not touch
these live parts, because serious injury or death may be the
result!
This symbol indicates that there are components under risk
from electrostatic discharge. To avoid equipment damages do
not touch these components or, observe the respective
handling rules!
For continued protection against fire, the fuses may only be replaced by identical fuses with the same
electrical specifications which are designed for the corresponding fuse positions.
No part of this publication may be reproduced in any form or by any means or used to make any derivative
work (such as translation, transformation or adaptation) without the written permission from BLANKOM
Digital GmbH. BLANKOM Digital GmbH reserves the right to revise this publication and make changes in its
content from time to time, whereby it shall not be obligatory for BLANKOM Digital GmbH to provide
notification of such revision or change.
BLANKOM Digital GmbH provides this manual without warranty of any kind, neither implied nor expressed,
this includes also any warranties regarding the merchantability and fitness for a particular purpose.
BLANKOM Digital GmbH may improve this manual or make changes in the products described herein at any
point of time.
Installation Notes
All types of the DRD/DRP family are 19“ devices with 1 RU height designed for installation in 19” racks. In
addition to the front panel screws an internal module support is required at the rack. At least 1 RU space is
required above the module for heat dissipation in the 19" rack.
Depending on the Frontend used and the operating adjustments, the input port carries DC voltage (13V /
18V, max. 500 mA).
By connecting a mains cable, the device can become functional without any auxiliary appliances. The power
supply units are not designed for the wide range of 100-240V AC; a manual adjustment of the voltage is not
necessary.
All the outputs are decoupled from one another. Thus, the circuit does not have any effect on the functioning
of the device. Connections that are not required need not be terminated.
Suggestion: CAT 6E Ethernet cable for GigEthernet
© 2009 BLANKOM Digital GmbH
All rights reserved!
