Author: RRi
Page 3+ 4
Version 1.0
Date: 13. July 2017
BLANKOM-EMU-8200_User_Manual_EN.docx
MPEG4 HD IP Encoder User Manual
1.5 Appearance and Description
Front and Rear Panel Illustration
From Left to Right:
Display, status LED's, Keypad, Enter-Button, Menu-, Lock- Unlock- Button
HDMI-inputs with extra screw-mounting, ASI-IN, 2x ASI Out, GbE-DATAPort, NMS Management port,
ON/OFF- switch, Power plug, Grounding connector screw
Note: The blind once RF-Test and RF-out are for Encoder versions with inbuilt modulators.
Chapter 2 Installation Guide
This section is to explain the cautions the users must know in some case that possible
injure may bring to users when it’s used or installed. For this reason, please read all details
here and make in mind before installing or using the product.
2.1 General Precautions
Must be operated and maintained free of dust or dirty.
The cover should be securely fastened, do not open the top case of the products
when the power is on.
After use, securely stow away all loose cables, external antenna, and others.
2.2 Power precautions
When you connect the power source, make sure to not overload it.
Avoid operating on an open wet floor. Make sure the extension cable is in good
condition
Make sure the power switch is off before you start to install the device
2.3 Device’s Installation Flow Chart Illustrated as following
Connecting
Grouding
Wire and
Power
Cord
Acquisition
Check
Installing
Device
Setting
Parameter
Running
Device
Connecting
Signal
cable
