Author: RRi
- 8 -
Version 1.0
Date: 13. July 2017
EMU-8500-series-operation-instructions.docx
MPEG4 HD IP Encoder User Manual
As soon as an Imput is automaticall detected, the Status will show it's parameters from the
HDMI source. Bitrates and other usual settings can be configured independently for every
encoder Channel and Module. For IPTV receivers we recommend using VBR instead of CBR
settings to safe bandwidth and do not end up in Peaks if bitrates which might cause
distortions if the CBR bitrate is peakly lower than the output settings. PCR-Correction should
be used to assure this method for the receivers for smooth streaming.
Parameters
→ TS Config:
From the menu on the left side of the WEB-IF, selecting “TS Config” displays the interface
where the user can configure the MPTS multiplexer output parameters.
First of all the General settings should be considered to adjust the MPTS output data rate, TS
ID, ON ID, PCR Correction values. Remark: IPTV STB's often can only see the first Service in a
multiplexed TS, for this case the SPTS modes are better to use.
•
TS Config→Stream select:
From the menu at the upper side of the webpage by using “Stream select” displays the
interface where the user can select program(s) to multiplex out and modify program info.:,
