Page - 18 -
BLANKOM HDC-6008CI EN 2017 V1.1, RR, 12-2017
HDC 6008CI
BAT and CAT are missing, CAT isn’t that critical because the transponder isn’t crypted at all.
All “other” named tables as well- but that is a must have filter when you transmodulate from SAT to
DVB-C anyway, because the network is different – and so the NIT.
In general:
TSID, ONID and some private PID’s should be observed and if needed : PID injected.
But: The most tables are somehow cross referencing. If you change a SID or remap a PID, the EIT is
not valid any more. AIT as well. BAT might also not fully work in the output network.
Also adding a TV Service from another source input cannot add it’s data to the existing EIT or other
tables.
This would be a job for an advanced Remultiplexer-Processor unit which is much more expensive
than this Transmodulator.
Note:
Be carefull for mixing TS – SAT In/outs and IP streams: To not overflow the final multiplexed QAM
output capacity which practical maximum is around 51 Mb/s ( minus peak-overhead reserve 10...15%
recommended) Example:
