User Manual professional h.264 & MPEG2 encoder MPE-4000
MPE-4000-MPEG-encoder-manual-RR-03-2018.docx
Page 12 / 44
Network setting
Enter “
Network
” to set the network. Submenus go as below:
Reset web
With this interface, by pressing ENTER again, you can select to reset the web-if. The operation
interface will turn up as following page:
NOTE:
Below explanations
are applied in this entire manual.
1) When you enter this submenu, the LCD shows only one option which is the device’s current
option which is marked with square bracket when you presses ENTER
again
to enter the
operation interface.
2) “01/02” in the up-right corner indicates there are all together 2 options and the LCD is showing
the 1
st
option currently.
Output setting
Enter “
Output Set
” to set the output parameters. Sub-menus works as below:
2.1.1 IP Address 2.1.2 Subnet Mask
2.1.3 Gateway 2.1.4 MAC Address
IP Address
192.168.000.136
Subnet Mask
255.255.255.000
Gateway
192.168.000.001
MAC Address
00:11:22:33:55:11
This is the IP address used for
connecting to Web management.
The MAC is read only on the front
panel. It is can be modified in the
Web management interface.
Reset web? Yes [01/02]
[Yes] No
The current mode
The current option and
total options
2.4.1 Mode 2.4.2 Bitrate
2.4.3 Dest IP 2.4.4 Dest Port
