12
PALIOS-IPM4
Part N
o
: 5105.10
8-fold IP-/ ASI-TV Modulator
IP/ SFP/ ASI (H.264/ AVC, MPEG2)
→
ATV (8x AM)
The following parameters are adjustable:
Program list (Transponder)
If “Program selection with select box“ in Setup
→
GUI settings is deactivated
(
»
chapter 9.2.6), the screen at the left for program selection is displayed. All
programs of the selected transponder are listed with name and service ID. The
selection of the program is done by marking the respective select box. The
program name and the other parameters of the program are applied automatically.
In this case the program name in the menu “Selected program“, variant 1 is not
selectable.
Input
input parameters of the channel
Input name
e.g. name of the program, editable
Input
selection: IP input channels 1 ... 8, ASI input
Selected program
variant 1: program selection menu
Program name
selection of the program from the program list of
the transponder of the selected IP TS
Load
reloads the program list
Service ID
displays the service ID of the selected program
Type
displays the type of the program
Language
selection of the available language
Direct input
selection menu, manual input (see below)
Selected program
variant 2: direct input
Program name
displays the name of the program, which was
selected in the input menu
Load
reloads the program list
Service ID
service ID of the requested program,
range: 0...65535
Type
selection of the program type: TV, Radio
Language
language number, range: 0..255
Output
output parameters of the channel
Frequency input
selection: channel, frequency
1
Output frequency
selection from channel table/ input in kHz
1
Output level offset
level offset
2
display
RF signal
selection: On, Off (Off at Time control „off“)
Sound deviation
selection: 30, 50 kHz
3
Sound carrier 2
adjustable in Setup menu for all channels
1
If frequency input “channel“ is selected, the output frequency can be chosen in the pre-
selected channel list (
»
GUI settings chapter 9.2.6). If “frequency“ is selected, then the output
frequency is selectable in kHz steps.
2
Adjustment of the offset of each channel to the basic level (
»
GUI settings chapter 9.2.6)
3
Only selectable, if sound carrier 2 is set to “Off“. If sound carrier 2 is set to “On“, the sound
deviation is permanently 30 kHz
Video
setting of the video parameters
Video output
selection: On, auto Off, auto color bar
Color bar
selection: On, Off
Color system
adjustable in Setup menu for all channels
Video format
selection: 4/3, 16/9
Scaling method
selection: none, pillar or letter box, fullscreen
center (cut out)
