Unit Specifications
4.
Transportation
1-16DB4-V2
Length
116 in
Width
60 in
Height
66 in
Weight
4500 lbs.
Blasting Width
16 in
General Transport of the Machine
Before the machine is used for the first time, Blastrac authorized dealers offer a course
to familiarize maintenance and operating personnel with all elements of the machine.
Blastrac is not liable for damage caused by incorrect use of the equipment by personnel
that have not trained by Blastrac.
Before the machine is transported, remove the abrasive from the machine and clean
the dust out of the dust collector.
Always drive carefully and in a manner to avoid the machine shifting. Tighten the
machine to the vehicle or trailer with straps or chains.
This machine is equipped with a tow valve. This valve allows fluid to pass through
the hydraulic pump without the motor being started. This allows you to move the
equipment without the use of the motor. If the valve is not closed, it will allow fluid
to pass through the pump and not move when the engine is stared. The valve is
located on the side of the hydraulic pump (see picture). Turn clockwise to close
(normal operation), turn 180° counter-clockwise to open (tow operation).
10
Tow Valve
Summary of Contents for 1-16DB4-V2
