2-45TDC Operating
Instructions
Safety instructions
13
Be sure that the operators and maintenance personnel are
familiar with the following:
Lubrication, cleaning and repair works can only be done when
the dust collector is in
standstill.
Make sure that the dust collector can not be set working during
the duration of the works.
Do not
open
or
remove protective guards
while driving gears
are running.
Once cleaning, lubrication or repair works are finished do not
forget to
fix
again the
safety devices
.
Do not touch any moving parts or stand in their path.
After cleaning, lubrication and repair works and before starting
the dust collector, be certain that no persons are in a dangerous
area.
2.11 Five golden rules
1. Disconnect all drives
2. Secure them against unintended restart
3. Check that there is no electric tension
4. Earthing and short-circuiting
5. Put a barrier or cover over under voltage standing
parts
Rules 4 and 5 are only prescribed for equipment over 1000 V.
Do not be persuaded by
third parties
to give up the required
switching-off
while repairing.
Only use tools that are in
good operating condition
. Damaged tools
should be
immediately repaired
or
replaced
.
Use the available
personnel protection equipment
and
safety
clothes
to protect you when you are working (e.g. safety glasses,
safety gloves safety shoes, etc.).
