Operating Instructions
6-54DC 208-230v/460-480 3Ø 60HZ
Dust Collector
October
2005
© Copyright Blastrac 10/11/05
5
Never use oversized fuses or bypass any fuses to operate the machinery. Always refer
to the electrical drawings provided for the individual machines for proper size and type
of overcurrent protection and fuses.
DO NOT SUBSTITUTE ANY OF THE ELECTRICAL COMPONENTS.
When replacing electrical components, care should be taken to use the exact
component that was originally supplied with the machine. These parts are listed in the
electrical section of this manual. The electrical components in these systems have
been coordinated for optimum protection of personnel and equipment –
DO NOT connect or disconnect power cables with voltage present or while under
load.
Disconnect all power connections
and observe lock out/ tag out procedures before
attempting maintenance or repair of any electrical or mechanical components.
Avoid all contact with rotating motor parts, drives or driven components.
Before energizing the equipment, check the condition of all power cables. While extra
hard usage Type W cable is provided with this equipment, damage can occur during
equipment transit. All cabling should be checked for cuts and worn condition prior to
connection to the power source.
Cable strain relief devices are provided for all power cabling. Assure that these strain
relief devices are secured to the frame of the equipment with the hardware provided
prior to energizing the equipment.
DO NOT start the equipment without first verifying it is connected to the proper
power source for voltage, frequency and phase.
While safeguards have been provided in this equipment to protect operating personnel
and equipment,
ALWAYS CHECK
that the proper power source is connected (voltage,
frequency and phase). Check the motors for proper rotation once the power source has
been verified. Sustained improper motor rotation can damage machine components.
