Operating Instructions
6-54DC 208-230v/460-480 3Ø 60HZ
Dust Collector
October
2005
© Copyright Blastrac 10/11/05
6
1.3 Safety - Dust Hopper and Ventilation Tips
DO NOT operate collector with excessive dust in the hoppers.
All Blastrac surface preparation equipment must be properly ventilated to be
environmentally effective. This benefits the operator, machine efficiency and
contributes significantly to better wear and less maintenance.
The level of dust in the dust hopper should be kept to a minimum. The importance of
checking the dust level during normal working conditions cannot be over-stressed.
Doing so keeps the surface preparation equipment internal components as clean as
possible, thereby eliminating the greatest cause of wear to the internal components of
the machine.
Do determine if the dust being collected is hazardous and comply with all
applicable local, state and federal regulations concerning protection against
explosion, fire, respirable dust and any other risk factor related to the dust
product being collected.
Cleaning the dust hopper at the end of each working day or shift is also very
important. Many types of dust (dependent on the surface being cleaned) have the
potential to easily ignite when left stored. The hazards of fires and explosions are
minimized when the dust is removed as recommended.
Wear appropriate respiratory protection when using or servicing the machine.
Breathable (respirable) silica dust may be generated by use of this product and can
cause severe and permanent lung damage, cancer, and other serious diseases. Do not
breathe the dust. Do not rely on your sight or smell to determine if silica dust is in the
air. Silica dust may be in the air without a visible dust cloud. If air monitoring equipment
for silica is not provided by your employer at your worksite, consult your employer and
OSHA regarding the appropriate respiratory protection or permissible alternate
protection methods such as air monitoring and warning equipment.
