21
5.4
Operating during grinding
This machine will always have an even grinding result because of the planetary system.
However it is advised to keep the machine constantly in movement for an optimum grinding result.
For soft floors it is recommended to work on high disc speed, for hard floors and the first steps of polishing it is
recommended to grind with low speed of the tools.
On hard floors and during polishing it is recommended to have a low grinding pressure.
In case of emergency or operating trouble, like vibrations or strong noises, switch the machine off
immediately!
Carry out grinding in parallel tracks in such way that the dust hose and electric cable do not become twisted.
The next figure shows the recommended grind paths leading away from the dust collector.
The advancing speed depends on the material of the surface to be treated and the desired profiling.
Regularly check the contents of the dust collector. Always wear a dust mask of at least class FFP3 when
emptying the dust bin or changing the dust bag /big bag. Observe and obey the local waste disposal
regulations!
Make sure that no vehicles, such as forklift trucks and other equipment run over the electric cable and the dust
hose.
For soft floors it is recommended to work with hard bonded diamond tools, for hard floors it is recommended
to grind with soft bonded diamond tools. See Chapter 4.6.
5.5
Wet grinding
The BMG-444 can also be used for wet grinding.
-Connect the machine to the water supply.
-Always use a clean water supply, dirty water could clog the system.
-
Make sure the water supply is turned off before connecting or disconnecting to the machine.
-
Be careful
, the work floor can get slippery when grinding wet.
-
Keep all electrical cables and connections away from water
IMPORTANT NOTE:
Do not use the dust collector, when grinding wet!
Clean the brush-sealing directly after wet grinding. It will be very hard to clean the brush-sealing when the
dust-water mixture has dried up and hardened.
1
Dust collector
2
Dust hose and
electric cable
3
Grinding machine
Summary of Contents for BMG-444
