Blata Blatino, User Manual

Service and Chain Adjusting: 
 
The chain adjustment can be seen on the Fig. 3. Unscrewing three bolts M 6 – 
914.007.01, which hold the engine to the frame from the bottom side of the 
SCOOTER, and moving the engine into the front can increase the chain 
tension. Check if the pinion is not orientated against the chain. When the chain 
is adjusted for 5 mm (1/4 inch) play tighten up the bolts. 
Regular lubrication of the chain increases its lifetime and protects from 
noisiness.  It is necessary to lubricate the chain after every engine wash or ride 
in the rain. It is recommended to use special spray oil for chains.  
 

Fig. 3 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
Tire Pressure: 
 
The general tire pressure depends on the weight of a driver and the character 
of the road. The average pressure is between 160 – 210 kPa (23 – 30 PSI). The 
higher rates are recommended for heavier drivers and the smoothest roads.  

STORAGE AND CUT OFF PERIOD 

For the storage period the fuel evaporation will occur. The fuel evaporation can 
cause malfunction of membrane pump. For this reason it is necessary once a 
month to refill the fuel into the fuel tank and pump it with the button “A” (Fig. 1) 
into the carburetor and /or restart the engine, too. 
The SCOOTER must be stored in a dry place and protected from dust. 
 
 
 
 
 
 
 
 

6 

5 mm