www.blaubergventilatoren.de
KoMFort roto ec S6(e)K 200
7
DESIGN AND FUNCTIONING
The unit has the following operating principle:
stale extract air from the room flows to the unit, where it is filtered. Then the air is moved through the rotary heat exchanger and is
exhausted outside with the exhaust fan. Clean air from outside is moved to the supply filter. Then filtered air flows through the rotary heat
exchanger and is moved to the room with the supply fan. Heat exchange between extract air and intake air takes place in the rotary heat
exchanger. Heat recovery minimizes heat losses and space heating expenses in cold seasons and cooling expanses in warm seasons.
The KOMFORT Roto EC S6EK 200 unit is equipped with an electric heater for preheating the supply air.
The unit is equipped with an additional extract spigot for connecting a kitchen hood.
The air handling unit is equipped with quick-detachable service panels for scheduled repair and maintenance operations.
1
2
3
4
5
6
7
8
9
10
11
12
A
C
E
D
B
1 – supply fan 2 – supply filter 3 – supply filter with higher level of filtering 4 – extract filter 5 – humidity sensor (option) 6 – rotary heat
exchanger 7 – control unit 8 – rotary heat exchanger drive 9 – electric PTC heater (for models equipped with a heater) 10 – kitchen hood
11 – Setup Mode button 12 – cable glands
A – spigot for intake air B – spigot for exhaust air C – spigot for supply air D – spigot for extract air E – additional spigot for optional remote
connection of a kitchen hood
