www.blaubergventilatoren.de
11
KOMFORT EC L S6
CONTROL PANEL MOUNTING
1. Unlock the latches with a screw driver through the openings in the bottom.
2. Remove the back cover.
3. Disconnect the cable from the terminal block.
4. Route the cable in the wall to the control panel installation site.
5. Fix the control panel back cover to the wall.
6. Connect the cable to the terminal block.
7. Install the front part of the control panel on the latches.
Fig. 7. Control panel mounting
Cut power supply to the unit off by turning the automatic electric switch QF
to OFF position prior to any operations.
Take steps to prevent activation of the automatic switch.
QF
CONNECTION TO POWER MAINS
WARNING
Read the operation manual prior to any electric installations. Connection of the unit to power mains is allowed by a qualified
electrician only.
The rated electrical parameter are stated on the rating plate. No modifications of internal connections are allowed and will
result in void warranty service.
Connect the unit only to power mains with valid electric standards.
Follow the respective electric standards, safety rules (DIN VDE 0100), TAB der EVUs. The house cabling system must be equipped
with an automatic switch at the external input. Connect the unit to power mains through the automatic switch. The contact
gap on all poles at least 3 mm (VDE 0700 T1 7.12.2 / EN 60335-1).
The automatic switch trip current must be not below the rated current consumption, refer Table 1. Install the automatic switch
to ensure prompt access.
