BLAUBERG Ventilatoren KOMFORT Roto EC S2 200, User Manual

www.blaubergventilatoren.de

KoMFort roto ec S2(e)200

10

CONNECTION TO POWER MAINS

ACCESS TO THE CONTROL UNIT

POWER OFF THE POWER SUPPLY PRIOR TO ANY OPERATIONS WITH THE UNIT.

THE UNIT MUST BE CONNECTED TO POWER SUPPLY BY A QUALIFIED ELECTRICIAN.

THE RATED ELECTRICAL PARAMETERS OF THE UNIT ARE GIVEN ON THE 

MANUFACTURER’S LABEL.

ANY TAMPERING WITH THE INTERNAL CONNECTIONS IS PROHIBITED  

AND WILL VOID THE WARRANTY.

•  The unit is rated for connection to 1~230 V/50 (60) Hz power mains. 
•  The unit must be connected to power mains using insulated electric conductors (cables, wires). The actual wire cross section 

selection must be based on the maximum load current, maximum conductor temperature depending on the wire type, insulation, 
length and installation method. 

•  The external power input must be equipped with an automatic circuit breaker built into the stationary wiring to open the electric 

circuit in case of overload or short-circuit. The circuit breaker installation place must provide quick access for emergency shutdown 
of the unit. The trip current of the automatic circuit breaker 

QF

 must exceed the maximum current consumption of the unit (refer 

to the technical data table).  The recommended trip current of the circuit breaker is the next current in the standard trip current row 
following the maximum current of the connected unit.  The automatic circuit breaker is not included in the delivery set.