BLAUBERG Ventilatoren KOMFORT Roto EC S2 200, User Manual

READ THE USER'S MANUAL BEFORE INSTALLING THE UNIT.

www.blaubergventilatoren.de

KoMFort roto ec S2(e)200

7

MOUNTING AND SET-UP

While mounting the unit provide enough access for maintenance or repair work. 
The minimum recommended clearances between the unit and the adjoining walls are 

given in the figure below.

When selecting a mounting location of the unit, provide free opening of the service panel.
To get the best performance of the unit and to minimize turbulence-induced air pressure 

losses, connect the straight air duct section to the spigots on both sides of the unit while 
installing.

Minimum straight air duct length:
equal to 1 air duct diameter on the intake side
equal to 3 air duct diameters on outlet side
If the air ducts are too short or not connected, protect the unit parts from ingress of foreign 

objects. 

To prevent uncontrollable access to the fan the spigots may be covered with a protecting 

grille or other protecting device with mesh width not more than 12.5 mm.

While installing the unit, ensure convenient access for subsequent maintenance and repair. 
The unit must be mounted on a plane wall. 
Installing the unit to an uneven surface could lead to the unit's casing distortion and 

operation disturbance.

The unit is designed for mounting on a horizontal plane as well as for wall mounting with 

a fixing bracket that is fastened with four screws and dowels (not included in the delivery set).

min 100 mm

min 1 m

UNIT WALL MOUNTING

1. Attach the wall mounting bracket to the wall using dowels with screws 
(not included in the delivery set). 
Attach the wall mounting bracket to the wall considering the wall material 
and the unit weight.

2. Install the unit on the mounting bracket. 
Suspend it carefully. 
Make sure the unit is fastened securely prior to operation.

THE UNIT MUST BE MOUNTED BY A QUALIFIED EXPERT ONLY, PROPERLY TRAINED AND 

HAVING THE REQUIRED TOOLS AND MATERIALS.