www.blaubergventilatoren.de
KoMFort roto ec S2(e)200
8
UNIT FLOOR MOUNTING
Place the unit on a flat, stable surface that has sufficient load capacity
matching the unit weight and meets safety requirements. Ensure a stable
position of the unit by screwing and unscrewing its feet.
HUMIDITY SENSOR MOUNTING
The humidity sensor is not included in the delivery set and can be ordered separately. The humidity sensor must be installed prior to unit mounting.
Remove the service panel and install the humidity sensor into the mounting bracket on the exhaust duct wall. Then connect the humidity sensor
connector to the respective contact socket on the control unit.
1
2
3
Contact socket for
connection to
the control unit
Humidity
sensor
Mounting bracket
Connector for
humidity sensor
connection
SERVICE SIDE CHANGE
1. Make sure of the correct unit service side selection.
Unit mounting position should enable free excess to the service panel for maintenance and service operations.
Supply air
Supply air
Intake air
Exhaust air
Exhaust air
Additional
spigot
Additional
spigot
Left-handed installation
Right-handed installation
Extract air
Intake air
Extract air
Summary of Contents for KOMFORT Roto EC S2 200
Page 1: ...Heat recovery air handling unit USER S MANUAL EN KOMFORT Roto EC S2 200 KOMFORT Roto EC S2E200...
Page 16: ...www blaubergventilatoren de KOMFORT Roto EC S2 E 200 16...
Page 17: ...www blaubergventilatoren de KOMFORT Roto EC S2 E 200 17...
Page 18: ...www blaubergventilatoren de KOMFORT Roto EC S2 E 200 18...
