www.blaubergventilatoren.de
Freshbox 100
10
5. To install an additional extract spigot remove the
plug on the rear part of the unit.
Undo the screws, remove the plug and fix a spigot on
its place using screws.
6. Insert the drain pipe and unit spigots into the
corresponding wall-mounted air ducts.
Open the unit door and remove the heat exchanger.
Remove the magnetic plug from the exhaust grille if
an additional extract spigot is not installed.
7. Fix the unit on the wall using the supplied screws
and expansion anchors.
Install the heat exchanger back and close the unit door.
Cut a part of the drain pipe protruding outside to
a length not more than 10 mm (3/8”).
Fix the outer hood on the outer wall of the building
(see the ventilation hood installation manual).
10 mm
3/8"
