11
4. CONTROLS
Button Function
Display/Led
A
Press and hold for approximately 1 second to turn the
hood on/off at speed
1
.
The display indicates
1
.
B
Press the “
-
” symbol and swipe your finger towards
the “
+
” symbol:
swipe once = speed
1
swipe twice = speed
2
swipe three times = speed
3
swipe four times =
Intensive
speed.
Intensive
speed is timed to run for 6 minutes. At the
end of this time the system will return to the speed
set previously.
Repeat the operation in the opposite direction to decrease
the speed (from the “
+
” symbol to the “
-
” symbol).
The display indicates the selected speed.
The display shows an animation when
Intensive
speed
is selected.
C
Press briefly to activate/deactivate
Delay
mode, causing
automatic shutdown of the Motor and the Lighting system
after 30 minutes. This mode cannot be activated if
Intensive or 24h modes are active.
Press the same button to deactivate the function or
press and hold button
A
for approximately 1 second to
turn the motor off.
Led
A
remains fixed and led
C
lights up. The display
shows an animation.
D
Press briefly to activate/deactivate
24h
mode.
This mode turns the motor on at speed 1 for 10 minutes
every hour. This mode cannot be activated if Intensive
or Delay modes are active.
Press the same button to deactivate the function or
press and hold button
A
for approximately 1 second to
turn the motor off.
Function activated: the display shows an animation and
led
D
flashes every 0.5 seconds.
E
Press briefly to turn the lighting system on and off at
maximum intensity.
Led
E
lights up.
Press and hold the button for approximately 1 second,
with all the loads turned off (Motor and Lights), to reset
the alarm when the filter alarm is triggered.
The display indicates F 3 times, showing that the filter
reset has been completed.
Metal grease filters:
the alarm is triggered after the Hood
has been in operation for 100 working hours.
With the motor turned off: the display indicates
F
+
1
alternately several times.
Activated charcoal filters:
the alarm is triggered after
the Hood has been in operation for 200 working hours.
With the motor turned off: the display indicates
F
+
2
alternately several times.
If both the alarms are active, the display will indicate
F
+
1
and
F
+
2
alternately several times.
F
Press briefly to turn the lighting system on and off at
medium intensity.
Led
F
lights up.
Press and hold the button for approximately 1 second
to enable/disable the charcoal filters alarm.
Filters alarm enabled: the display indicates
F
+
2
Filters alarm disabled: the display indicates
F
+
0
G
Press briefly to activate/deactivate the button pad lock
to allow cleaning of the hood.
Led
G
remains fixed while the other leds flash.
Summary of Contents for 5DS69760
