A. Lift the handlebar stem to the upright position; lock the folding device by lifting the key upwards
as far as possible, then secure the key against self-locking.
B. Connect the plugs of the wires standing proud from the handlebar and the stem, and then
assemble the handlebar by properly inserting it into the upper part of the stem.
C. Line up the holes in the upper part of the stem with the threaded holes in the handlebar; screw in
the four screws supplied and then tighten them using a wrench. Check that there are no
clearances in the handlebar and stem connection; if there are any, tighten the retaining screws.
Adjust and tighten the brake lever accordingly.
D. To eliminate the clearance in the scooter’s folding device with the wrench, first adjust the
tightening of the screw at the front of the device. When scooter is on the road, check the tightness
of the screws regularly. Turn the scooter on with the power button.
2. Scooter folding
A. Tilt the key lock upwards and press in the key of the mechanism as far as it will go;
B. Tilt the lock on the top of the handlebar stem and attach it to the rear-mudguard attachment
socket;
C. Make sure the two attachments are connected and you can lift the scooter by the handlebar stem;
C
D
C
A
B
ESC608
7
