9
English
Remote Keypad (KP-R1)
(included in Kit Q-Pro 6600)
With the Blaupunkt keypad KP-R1 You can easily change the status
of the Security System between Arm, Disarm and Home mode.
Enter the Security System PIN code (same as set in chapter 5) and
press the desired mode button.
We recommend to mount the keypad at the door entrance for
entry control.
Remove the back cover and push through the 2 knockouts on the
back (for example with a screwdriver) where plastic is thinner. Drill
holes into the wall using the knockouts as template. Fix the keypad
base onto the wall with the screw and plugs provided. Place back
the back cover onto the Keypad.
Make sure that the tamper protection is pressed down against the
wall surface, otherwise the accesory will trigger a tamper alert.
1
2
3
4
5
6
7
1.
Active LED (Blue/Orange)
2.
Status LED (Blue/Red)
3.
Fault LED (Orange)
4.
Away Arm Key
5.
Home Arm Switch
6.
Status Key
7.
Disarm Key
Pet immune Motion Detector with camera (IRC-P4)
(included in Kit Q-Pro6600)
When the IRC-P4 detects an movement during arm-mode, it will
automatically take 3 photos, save them on the cloud, trigger an
alarm and notify the user. User can request and see the photos at
any time using the App or the Web Portal. The tamper protection
is inside the device and is pushed down by the screw. If the device
is removed by an intruder, the tamper protection will trigger an
alarm.
The IRC-P4 needs to be mounted or glued to the wall with screws
or adhesive tape. The best location is in a corner to have wide
motion detection range. Install he motion detector at 2m above
the ground, for best performance.
Remove the back cover and push through the knockouts on the
back (for example with a screwdriver) where plastic is thinner.
There are six knockouts on the back of the device that can be
pushed through If you mount the device in a corner, push through
the perforations on the side; if you mount the device on a plane
surface, push through the perforations in the center. Drill holes
into the wall using the knockouts as template. Fix the IRC-P4 base
onto the wall with the screw and plugs provided. Place back the
back cover onto the IRC-P4.
The pet immune feature and will ignore pets up to 25kg. For a
correct pet immune detection do not aim the motion detector at
stairways or areas where a pet can climb on.
Fig.4
NOTE: The IRC-P4 will go on sleep mode for 2
min. when detecting someone while alarm is
deactivated. Please wait more than 2 minutes
without detecting anyone to be sure the
device is out of sleep mode before testing.
For more information about the accessories included on the kit visit service.blaupunkt-security.com for detailed
user manual for each accessory.
The Q-Pro Series equipped with rolling code. A feature to encrypt and make the Security System even more
secure against so called replay attacks.
LED-Flash
PIR-Sensor
Lense of PIR-
Camera
Blue LED/Test-/
Learn-Button
Fig.5
