36
6.3 Door Contact
•
Door Contact LED flashes when activated:
The Door Contact has low battery or the tamper switch is triggered.
•
Door Contact does not respond to door/window opening
Batteries may be exhausted, please change the batteries.
The magnet is too far away from the Door Contact. Please check the gap between the magnet and the Door
Contact. Reduce the gap and test the Door Contact again.
6.4 Factory Reset
The Factory Reset function will clear all device info and returns all system parameters to their default value. After
resetting, you will need to set up the system again by following the corresponding instructions in the Quick Start
Guide and this manual.
• Power down the Control Panel by disconnecting the AC Power cord and switching the battery switch to OFF.
• Apply AC Power while holding down the button on the back of the panel.
• Keep holding the button for about 5 seconds until the panel emits a long beep and turns on all 3 LEDs.
• Release the button – the factory reset is completed.
Summary of Contents for Q SERIES
Page 34: ...34 About...
