Blaupunkt SA-BM01H, User Manual

7

CHARGING

OPERATING

MAINTENANCE CLEANING STORAGE

●  

Fully charge battery for up to six hours before first use either attached or detached from the device

●  

To charge, connect the dc end of the supplied 24V adapter to the battery´s charging port and plug ac 

    side cable into wall outlet

●  

LED band on battery lights pulsate to show battery level and indicate active charging

●  

With battery attached, LED lights on unit flash to show battery level and indicate active charging

●  

Full charge is indicated when all LED lights stop flashing and remain fully illuminated

●  

Battery may be recharged at any time and at any battery level

●  

It is not recommended to fully deplete the battery to the red led level

●  

The average run time is 2+ hours depending on speed level and pressure applied during use

●  

Align and attach battery into base of und-ensure it is securely locked in place

●  

Power device on by moving the power switch on the bottom of the battery to the on position power device off 

    by moving the power switch to the OFF position

●  

With power switch in ON position, press the power button once to tum device on to level one twice to turn device 

    to level two and three times for level three. Pressing the power button again will tum the device off, the blue LED 
    lights will indicate the corresponding power level

●  

With unit off, fully insert applicator by pressing in. Remove by pulling it on

●  

Massage desired body part at the desired speed applying pressure as needed

●  

To remove the battery, lightly press the battery release button with thumb firmly pull downwards on the battery 

    handle with the other hand

●  

Use a slightly damp towel to clean device and a dry with a soft doth

●  

For storage or travel, remove battery and store in supplied carton box