19
INTRODUCTION
NAVIGATION
RADIO
CD / MP3
CD CHANGER
SETUP
APPENDIX
Switching on a coded device after disconnection
from the battery power supply
If you switch on a coded device after having disconnected it from the battery
power supply (e.g. after carrying out repairs to the vehicle), the system will dis-
play a message asking you to enter the code. You will find the numerical code
printed on your device’s equipment pass. Never keep the equipment pass in the
vehicle!
To enter the numerical code, proceed as follows:
1
For the first digit of the numerical code: press button 1
>
repeatedly until
the first digit of the code appears in the display.
2
For the second digit of the numerical code: press button 2
>
repeatedly
until the second digit of the code appears in the display.
3
For the third digit of the numerical code: press button 3
>
repeatedly until
the third digit of the code appears in the display.
4
For the fourth digit of the numerical code: press button 4
>
repeatedly until
the fourth digit of the code appears in the display.
Once you have finished entering the whole numerical code and it is shown in the
display,
5
press and hold down the OK button
;
for longer than 2 seconds.
✔
The device switches on.
Alternatively, you can enter the numerical code using the menu knob
:
and the
OK button
;
.
1
To do so, turn the menu knob
:
until the required digit appears in the dis-
play.
2
Press the OK button
;
to mark the next input position in the numerical
code.
3
Repeat steps 1 and 2 for the remaining digits of the numerical code.
CODE
O
O O O
1 BA TPAmsterd_gb
26.09.2005, 12:45 Uhr
19
