Proper system planning is vital in order to maximize the
device’s performance and road safety. Plan your installa-
tion carefully to avoid compromising performance reli-
ability of the system. Consult an authorized Blaupunkt
dealer for installation or reparation. Read the manual
carefully before operating the device for the first time.
Safety Notes
Ensure to follow below safety notes during
installation and wiring connection : -
•
•
•
•
Installation and Connection Instructions
•
•
•
Voltage Supply
•
•
•
•
Integrated Fuse
The integrated fuse in the device protects the
output voltage and the entire electrical system in
case of malfunction. Do not replace damaged
fuse with higher current.
CAUTIONS
Switching On/Off
This device will automatically turn on if a music
signal is detected. The device will also
automatically turn o if no music signal is received.
Remote Control
Disclaimer
In no event shall Blaupunkt be liable for any direct,
indirect, punitive, incidental, special consequential
damages to property or life and whatsoever arising out
of or connected with the use or misuse of our products.
USA & CANADA: This product is not intended for sale in
the United States and Canada. If purchased in the U.S. or
Canada, this product is purchased on as-is basis. No
warranty, whether expressed or implied is provided in
the U.S. or Canada.
Recycling and Disposal
Do not dispose of your old unit in the
household trash!
Use the return and collection systems
available to dispose of the old device.
This manual may be updated from time to time without
any notice.
1
Disconnect the negative terminal of the
battery. Refer to the safety notes of vehicle
manufacturer.
Ensure positions of the holes are nowhere
near the vehicle component to avoid any
damage during drilling.
Ensure cross section of the cable is no less
than 2.5mm2 if the positive and negative
cables are too long.
Incorrect installation may result in
malfunction of the device or the car sound
system.
Select a dry and well-ventilated location
to install the device.
The device must not be installed in overly
exposed location such on the rear shelf,
rear seat etc.
The installation location must be suitable for
screw holes and have stable ground support.
Use the supplied power extension cable to
connect to the positive battery terminal.
Firmly and carefully connect the ground lead
to a bare metal point on the vehicle chassis.
The control of the device should be a
two-channel control, either via the preamplier
outputs or the loudspeaker, output of the car
sound system.
A control solely via the right or left channel is
also possible since the low-frequency portion
of the music is generally identical on both
channels.
•
Gain adjustment :
Turn the gain knob to adjust
the volume to the desired
level.
