PAGE 29
OM-9603
Revision Date: 12/15/04
Date Printed: Tuesday, February 08, 2005
This unit is equipped with an Ignitor Interlock System. The pilot will not light unless the
viewing door is open and the main burner will not light unless the viewing door is closed.
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information on the previous page.
2.
Controls are accessed by opening the right side door panel.
3.
Set the optional wall thermostat to lowest setting, or switch the Stove On/Off Switch to the off position.
4.
Push in the gas control knob slightly and turn clockwise to OFF.
NOTE: The knob cannot be turned from PILOT to OFF unless the knob is pushed in slightly. DO NOT FORCE.
5.
Open the viewing door and wait five (5) minutes to clear out any gas. If you smell gas STOP! follow step B
in the safety information on the previous page. If you do not smell gas, go the step 7.
6.
Turn Control Knob counter clockwise to PILOT position.
7.
Depress control knob and push in the Piezo ignitor button. Once pilot ignites, continue to hold the control
knob in for about one (1) minute after the pilot is lit. Release the knob and it will pop back up. Pilot
should remain lit. If it goes out, repeat from step 5.
∗
If the knob does not pop up when released, stop and immediately call your service technician or gas
supplier.
∗
If the pilot will not stay lit after several tries, turn the gas control knob to OFF and call your service
technician or gas supplier.
8.
Close the viewing door and turn the gas control knob counter clockwise to ON. Turn on all electric power to
the appliance. Set the thermostat to desired setting, or if you are not using the thermostat then switch the
Stove On/Off Switch to the on position.
NOTE: IF THERMOSTAT IS TO BE USED, THE STOVE ON/OFF SWITCH SHOULD BE IN THE OFF
POSITION. IF SWITCH IS LEFT ON, THE STOVE WILL CONTINUE TO RUN AND THE THERMOSTAT WILL
HAVE NO EFFECT.
NOTE: Fan operation is controlled by the temperature of the stove. It will turn on after the stove reaches
approximately 200 degrees F and will run after the stove is turned off until it cools down.
TO TURN OFF GAS APPLIANCE:
8.
Set the thermostat to lowest setting or if you are not using the thermostat then switch the Stove On/Off
Switch to the off position
9.
Push in the gas control knob slightly and turn clockwise to OFF. DO NOT FORCE.
10. Turn off all electric power to the appliance if a service is to be performed.
PILOT
ADJ.
IN
ON
T
H
T
P
T
P
T
H
OUT
PIL
O
T
O
FF
TH
TP
TH
TP
LO
H
I
VENT
OU
T
IN
ON
OF
F
P
I
T
O
L
P
IL
O
T
A
D
J
.
OFF
ON
Pilot Line
Piezo Push
Button Ignitor
Stove
On/Off
Switch
Connect To
Thermostat
Manifold
Testing
Access
Hi/ Low
Flame
Control
Control
Knob
Manifold
Testing
Access
Piezo Push
Button Ignitor
Connect To
Thermostat
Connect To
Thermostat
Manifold
Testing
Access
Control
Knob
