PAGE 21
OM-9703
Date Printed: Thursday, July 05, 2007
Revision Date: March 6, 2006
1.
STOP!
Read the safety information on the previous page.
2.
Controls are accessed by opening the right side door panel.
3.
Set the optional wall thermostat to lowest setting or switch the Stove On/Off Switch to the off position.
4.
Push in the gas control knob slightly and turn clockwise to OFF.
NOTE:
The knob cannot be turned from PILOT to OFF unless the knob is pushed in slightly.
DO NOT FORCE.
5.
Wait five (5) minutes to clear out any gas. If you smell gas
STOP!
Follow step B in the safety information
section on the previous page. If you do not smell gas, go the step 7.
6.
Turn Control Knob counter clockwise to PILOT position.
7.
Depress control knob and push in the Piezo ignitor button. Once pilot ignites, continue to hold the control knob
in for about one (1) minute.Release the knob and it will pop back up. Pilot should remain lit. If it goes out,
repeat from step 5.
If the knob does not pop up when released, stop and immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several tries, turn the gas control knob to OFF and call your service
technician or gas supplier.
8.
Turn the gas control knob counter clockwise to ON. Turn on all electric power to the appliance. Set the
thermostat to desired setting, or if you are not using the thermostat, switch the Stove On/Off Switch to the on
position.
NOTE: IF THERMOSTAT IS TO BE USED, THE STOVE ON/OFF SWITCH SHOULD BE IN THE OFF POSITION.
IF SWITCH IS LEFT ON, THE STOVE WILL CONTINUE TO RUN AND THE THERMOSTAT WILL HAVE NO
EFFECT.
NOTE: Fan operation is controlled by the temperature of the stove. It will turn on after the stove reaches
approximately 130 degrees F and will run after the stove is turned off until it cools down.
TO TURN OFF GAS APPLIANCE:
8.
Set the thermostat to lowest setting or if you are not using the thermostat then switch the Stove On/Off Switch
to the off position
9.
Push in the gas control knob slightly and turn clockwise to OFF.
DO NOT FORCE.
10. Turn off all electric power to the appliance if a service is to be performed.
LIGHTING INSTRUCTIONS
PILOT
ADJ.
IN
ON
TH
TP
TP
TH
OUT
PIL
OT
O
FF
TH
TP
TH
TP
LO
H
I
VENT
OU
T
IN
ON
OF
F
P
I
T
O
L
P
IL
O
T
A
D
J
.
OFF
ON
Pilot Line
Piezo Push
Button Ignitor
Stove
On/Off
Switch
Connect To
Thermostat
Control
Valve
Manifold
Testing
Access
Hi/ Low
Flame
Control
Knob
Control
Knob
Manifold
Testing
Access
Piezo Push
Button Ignitor
Connect To
Thermostat
Connect To
Thermostat
Manifold
Testing
Access
