Blaze Outdoor Products Instructional Book
Page | 11
Version 1.4
Keep any electrical supply cord and fuel supply hose away from any heated surfaces, sharp edges and dripping
grease.
Be certain your appliance is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this appliance, continuity must exist between the
appliance and an effective grounding system. It is imperative that this basic safety requirement be met. The
manufacturer cannot be held responsible for damages caused by the lack or inadequacy of an effective
grounding system.
Do not operate any appliance with a damaged power cord or power plug, and do not operate any appliance after
the appliance malfunctions or has been damaged in any manner. If this should occur, return the appliance to the
nearest authorized service facility for examination, repair or adjustment.
Be certain your appliance is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this appliance, continuity must exist between the
appliance and an effective grounding system. It is imperative that this basic safety requirement be met. The
manufacturer cannot be held responsible for damages caused by the lack or inadequacy of an effective
grounding system.
This appliance conforms to all uniform electrical safety codes and electrical grounding regulations. Install unit
according to I.A.W. local codes or with National Electrical Code ANSI/NFPA 70 or CSA C22.1 in their absence.
Gas Safety and Installation Warnings
Always check the Rating Plate to make sure the gas supply you are hooking up to is the gas type the
appliance is manufactured for.
Check the rating label on the left hand side of the unit.
Do not twist the gas supply hose.
Before each use, visually inspect the gas supply hose for cracks, cuts or excessive wear. Replace the
hose if necessary. Check for gas leaks.
Gas Specifications: Be sure that the gas supplied to the appliance conforms to the model you
RATING PLATE LOCATION
