Blaze Outdoor BLZ-WVH-42, User Manual

| 

BLAZE OUTDOOR

MOTOR ROTATION INSTRUCTIONS

The image to the right shows the position of the motors directly from the 

factory This position of the motor is used when running vertical pipe for 

your venting. 

STEP 1

There are two sets of screws you will be working with on the cover plate. 

The smaller screws closest to the edges of the plate hold the plate to the 

hood itself. The larger screws closer to the center hold the motor to the 

cover plate.  Remove all of the smaller screws holding the cover plate to 

the hood body. 

Getting Started

REMOVE COVER PLATE

STEP 2

Next, remove all of the larger screws,which hold the motor to the cover 

plate leaving the center screw .  The center screw to be left in place can 

be seen in the below image. 

REMOVE MOTOR SCREWS

STEP 3

DETACH MOTOR FROM PLATE

Holding the center of the motor, remove the 

fi

nal screw, which will free 

the motor from the cover plate. Lower the motor gently until it comes to 

resting position.  

STEP 4

ROTATE MOTOR

At this point, the cover piece can be removed and you are ready to rotate 

the motor to the horizontal discharge position. When lifting the motor out 

of the housing, tilting the motor down on one side is typically the best 

method for getting the motor out of the opening. 
Once out of the hood, simply rotate 180 degrees and place the motor back

into the hood. For both the removal and reinstallation of the Motor, be 

careful not to pinch the wiring.  Allow it to rest at the initial position when 

you started.

STEP 5

REPLACE THE COVER PLATE

Next, re

‐

install the cover plate with the discharge in the horizontal 

position.  The cover plate can be reattached with the small screws.

STEP 6

ATTACH THE MOTOR

Re attach the motor to the cover plate. Start with the center screw 

which was the last screw removed when the motor was disattached. 

Once the initial screw is in place, attach the remaining screws to 

hold the motor onto the cover plate. 

STEP 7

SECURE LOOSE CABLES

You will 

fi

nd some of the connecting cables now lying below the motor.  Secure wires above motor and the  

rotation process is complete.  Repeat same process for additional motor.

8