Blaze Outdoor Products Instructional Book
Page |
33
Version 1.0
P a g e
|
12
BURNERS CLEANING & MAINTANANCE
Burners are made of heavy gauge stainless and can be cleaned using a bristle brush, warm
water and soap. Check every port hole for clogs. Use a wire pin to clean out clogged ports.
Make sure the burner is dry before installing it back to the Power Burner.
WARNING
!
IT
IS
CRITICAL
THAT
THE
GAS
BURNERS
ARE
PROPERLY
INSTALLED
WITH
THEIR
ORIFICES
INSIDE
THE
BURNERS
AIR
SHUTTERS.
If
not
properly
installed,
gas
may
leak
outside
of
the
burner
that
could
lead
to
fire,
potential
damage
to
your
Power
Burner
and
bodily
injury.
DRIP
PAN
The drip pan collects grease, liquid and fallen food particles. Allow the pan and its contents to
cool before cleaning. Slide the pan out and wipe it clean. Make sure the drip pan is fully inserted
back into the Power Burner. It is required to clean the pan after every use to avoid any possibility
of a grease fire. DO NOT use the Power Burner without the drip pan pushed all the way to the
back of the Power Burner unit.
OPERATING
INSTRUCTIONS
BEFORE
LIGHTING
THE
POWER
BURNER
1) Always check the power burner for gas leaks before each use and do not attempt to light the
power burner if you smell gas. Call the gas company or a professional to check the connections.
2)
WARNING
!
IT
IS
CRITICAL
THAT
THE
GAS
BURNERS
ARE
PROPERLY
INSTALLED
WITH THEIR
ORIFICES
INSIDE
THE
BURNERS
AIR
SHUTTERS.
If
not
properly
installed,
gas
may
leak
outside
of
the
burner
that
could
lead
to
fire,
potential
damage
to
your
Power
Burner
and
bodily
injury.
Inspect the gas supply piping and hose prior to turning the gas ON. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to use. The replacement pressure regulator and
hose assembly must be the type specified by the manufacturer. Do not use the Power Burner if
the odor of gas is present. Call the gas company or a professional to check the connections.
If the unit is LP, attach the regulator and hand tighten to the valve of the cylinder and leak check
the hose and regulator connections with a soap and water solution before operating the Power
Burner.
Always keep your face and body as far away as possible when lighting.
Refer to spiders and insects warning and procedure under the cleaning and maintenance page
of this manual.
