It is possible to change the default actions of the wBox controller after
pressing a given button on the remote control. Connect to the given driver
with the wBox app and go to its settings menu. In the "Remotes" section, next
to the given remote control, click on the key icon - a pop-up will appear, in
which for a given action group, it is possible to change the action type for the
5
CHANGING DEFAULT KEY FUNCTIONS
Ultra-safe communication
Pilot μRemote uses cryptographic technologies used in banking, many times
more effective than those currently used, including two-way key negotiation,
confirmation communication and encryption using elliptical curves.
6
SECURITY
TECHNICAL SPECIFICATIONS
number of buttons
4
dimensions
72 x 39 x 13 mm
power supply
lithium-polymer battery
charging
standard microUSB charger 5V
(not included)
radio frequency
2.4 GHz
transmission type
with confirmation, encrypted
µWiFi
transmission protocol
signaling
haptic Feedback Display
LED RGB diode
yes
ADDITIONAL INFORMATION
UPDATING THE SOFTWARE
DEFAULT BUTTON REACTION
DEPENDING ON THE CONTROLLED PRODUCT
2 seconds
b)
c)
3 seconds
d)
3 seconds
e)
3 seconds
pressing the button , it is necessary to press and keep pressed the button
aaa
. The control remote immediately unpairfrom all the controllers in this
group and will not be able to control them anymore. It should be noted that
in the controller settings, in the “Remote controls” section, the given pilot will
still be visible in the device list.
selected button - of the pilot. The behavior of the button can not
be changed.
Prepare the remote control for updating by recharging it and pairing it with
the controller. Next connect to the controller with the phone by using the
wBox application and go to its settings menu.
If a new version of the software is released, the update icon will appear in the
“Remote controls” section of the remote control. Clicking on the icon will
appear an appropriate with the message about the possibility of updating the
software in the remote control. Then is necessary within a maximum of 30
seconds, induce the remote control into the update mode following the
remote control pairing procedure in accordance with points a) - d). However,
in the point e), instead of pressing the button , it is necessary to press the
button for a long time (about 2 seconds). The remote control will blink the
LED in the color of the current group and will remain on during update (about
3 minutes).
After properly carried out the update, the diode will turn off immediately.
If the LED lights blink on red color - an error has occurred, then repeat the
whole procedure.
number of connected
devices / channel
3
device
button
button
button
up
stop
down
first output
gateBox
second output
without
open
doorBox
without
without
increase by 33%
decrease by 33%
decrease by 33%
switch off/
switch on (last)
change
the output state
switch off
switch on
change
the output state 2
set blue color
set relax effect
change
the output state 1
change the state
of both outputs
switch off/
switch on (last)
switch off/
switch on (last)
increase by 33%
dimmerBox
switchBoxD
wLightBox
wLightBoxS
switch off/
switch on (last)
saunaBox
for more information
visit our website
www.blebox.eu
or send us an email to: info@blebox.eu
support is available at support@blebox.eu
shutterBox
shutterBoxDC
rollerGate
switchBox
switchBoxDC
increase by
5°C
decrease by
5°C
