Blendtec CLASSIC SERIES, Owner'S Manual And User'S Manual

11

You can switch to a different speed at any point during the cycle� To stop the cycle 

at any point during blending, press Stop�

PULSE

The Pulse button is used for chopping, mincing, whipping, or other momentary 

tasks that do not require a long blend cycle� You can also use the Pulse button to 

quickly stir a blend before serving�
The Pulse setting runs at speed 7 and will only run while the Pulse button is held 

down� When the button is released, the motor shuts off�

SECTION 6: CARE AND CLEANING

6.1

 CLEANING AFTER USE

1� Add 1 cup (240ml) of hot water and a drop of liquid dishwashing soap to the 

blender jar�

2� Place the lid tightly onto the jar�  
3� Place the blender jar on the blender base and, with your hand placed on top of the 

lid, press the CLEAN cycle button� 

4� Rinse well�
5� Clean the blender base by simply wiping the base and interface with a damp cloth�

6.2

 LONG-TERM SANITATION

1� For long-term sanitation, fill the blender jar with hot water� 

2� Add one teaspoon of liquid chlorine bleach to the FourSide jar or two tea-

spoons to the W jar�

3� Stir for 10 seconds to mix water and bleach�  Let mixture stand in blender jar for  

five minutes�

4� Empty water/bleach mixture�  Turn jar upside down on dish rack until dry�

6.3

 CLEANING TIPS AND CAUTIONS

• Do not use stiff bristled brushes or abrasive cloths/pads to clean the blender base 

or jar, as this will dull or scratch the surface�

• NEVER submerge the blender motor in water� Avoid submerging blender jars for 

more than 5 minutes� Water penetration through the lower jar seals will reduce the 

life of the jar� After cleaning, we recommend the blender jar be stored upright�

• BLENDER JAR IS DISHWASHER SAFE—TOP RACK ONLY!  Extreme temperatures 

damage the lower seal of the jar� We recommend hand washing to prolong the 

life of the blender jar� We do not recommend the jar be used for temperatures 

above boiling (212°F, 100°C)�