www.blendtec.com
Remember...
1.
If the mill slows down, the pan may be too full, the filter may need
cleaning, or the cyclone cup may be full or positioned incorrectly. Make sure the F-
shaped filter is properly placed.
2.
Do not attempt to overfill the pan. It is a simple matter to empty the contents and
continue your milling.
3.
Do not attempt to run wet wheat or other wet grain through the mill. The Kitchen
Mill™ is not designed to mill wet grain. Moisture content of grain should not exceed
15%. Check the back of this manual for a list of approved grains.
4.
The mill is designed for household use only. Commercial use will void the war-
ranty.
5.
The mill is fast, efficient, and easy to use. It is not, however, intended to be a metal
grinder. Some grains do contain pieces of metal like BeeBees, nails, staples, etc. We
suggest you use only double or triple cleaned grain. Your warranty excludes foreign
objects that are introduced into the mill.
6.
The mill is designed to mill grains, not herbs or seeds. Do not place sunflower or
sesame seeds, coffee or peanuts in the mill, as they may gum up the mill. Oil content
should not exceed 15%.
7.
Never immerse the milling unit in water.
8.
Do not attempt to repair your Kitchen Mill™. If you suspect that repairs are neces-
sary, follow the repair procedure listed on page 1 of this manual.
9.
The mill has been equipped with a circuit breaker next to the power switch to pre-
vent the motor from electrical overload. In the event the breaker is activated, the mill
will automatically shut off. Unplug the mill and allow it to cool for 5-10 min. Plug the
mill in and simply reset it by depressing the white button located on the top of your
mill. If the breaker is activated again, contact the Blendtec™ service department,
800-748-5400
