background image

13

12

WHOLE JUICE 

This cycle is designed to completely blend tough and dense ingredients, 

including carrots, celery, and seeds� Use the Whole Juice cycle if you are using 

any fruits and/or vegetables with stems, seeds, or skins� 
When blending carrot juice or other dense juices, you may need to repeat this 

cycle once or twice until the desired texture and consistency are achieved�

HOT SOUP

This cycle is designed for hot recipes� The cycle’s length of time, combined with 

the speed of the motor, heats the ingredients to a hot temperature� This cycle 

can also be used for hot chocolate, syrups, and fondue�
When using fresh ingredients, remember that the speed of the blade generates 

enough heat to warm the ingredients� Do not add any liquids or ingredients over 

115° F to the jar when preparing soups or hot items�

PULSE

Use Pulse for chopping, mincing, whipping, or other tasks that do not require a 

long blend cycle� You can also Pulse to quickly stir a blend before serving�
The Pulse setting runs at speed 7 and will only run while the Pulse icon remains 

pressed� When the icon is released, the motor shuts off�

CAPACITIVE TOUCH SLIDER

The capacitive touch slider allows you to fine-tune the speed of your blender� 

Simply slide your finger to the right to increase the blender’s speed or the left to 

decrease speed�

MODE

Press Mode to switch between using the manual touch slider and the  

preprogrammed blend cycles�

SECTION 5: CARE AND CLEANING

5.1

 CLEANING

1� Add 1 cup (240ml) of hot water and a drop of liquid dish soap to the blender jar�
2� Place the lid tightly onto the jar�  
3� Place the blender jar on the blender base and, with your hand placed on top of 

the lid, press the Pulse button for 5 seconds�

4� Rinse well�
5� Clean the base by simply wiping the base and interface with a damp cloth�

5.2

 LONG-TERM SANITATION

1� For long-term sanitation, fill the blender jar with hot water� 
2� Add one to two teaspoons (5-10ml) of liquid chlorine bleach to the jar�
3� Stir for 10 seconds to mix water and bleach�  Let mixture stand in blender jar  

for five minutes�

4� Empty water/bleach mixture� Turn jar upside down on dish rack until dry�

4.2.4

 ALL ABOUT BLEND CYCLES

Blend cycles are timed cycles designed for specific types of blends� These  

one-touch cycles speed up, slow down and shut off automatically, so results  

are perfect every time� 
Each blender in the Professional series features a number of pre-programmed 

cycles and settings that provide a wide range of recipes and functions:

Batters

 — sauces, dips, dressings, batters

Mixed Drinks

 — mixed drinks, milkshakes, crush ice

Smoothie

 

— fruit smoothies, green smoothies, milkshakes

Frozen Treats 

— ice cream, frozen yogurt, sorbets

Whole Juice 

— juices, green drinks

 

Hot Soup 

— soups, hot chocolate, syrups, fondues

Pulse

 — stir, chop, or mince at a high speed

BATTERS

This cycle stays at relatively low speeds for shorter periods of time� This 

combines your batters or dips, allowing the flavors to blend together properly, 

without over-mixing�
To use the Batters cycle, load your jar as indicated in the recipe you are using, 

secure the lid, and press the Batters icon� The blender will run the cycle and 

automatically shut off�

MIXED DRINKS

This cycle is used for mixed drinks, iced coffees, and milkshakes� The length of 

time creates a consistency that is ideal for these types of recipes�
To use the Mixed Drinks cycle, load your jar as indicated in the recipe you are 

using, secure the lid, and press the Mixed Drinks icon�

SMOOTHIE

This cycle is designed specifically for various types of smoothies and thick 

drinks that frequently use dense or frozen ingredients�  It slows down and 

speeds up automatically during the course of the cycle� This allows the blender 

to draw the ingredients into the blending vortex, creating the desired texture�
To use the Smoothie cycle, load your jar as indicated in the recipe you are using, 

secure the lid, and press the Smoothie icon� The blender will run the cycle and 

automatically shut off�

FROZEN TREATS

This cycle is designed specifically for frozen treats, including ice cream, sorbets, 

and frozen yogurt� The cycle speeds up and slows down at the appropriate 

moments to ensure your blends stay frozen�
To use the Frozen Treats cycle, load your jar as indicated in the recipe you are 

using, secure the lid, and press the Frozen Treats icon� The blender will run 

the cycle and automatically shut off� After creating your frozen dessert, serve 

immediately and store leftovers in the freezer�

Summary of Contents for PROFESSIONAL 750













Reviews: