4
Operation of the HopRocket
tm
as a hopback:
The HopRocket
tm
is manufactured with ½” male NPT fittings on each end. We recommend Blichmann
Engineering QuickConnector
tm
fittings as shown in Fig 8 but any suitable fitting will work with the
product. Our line of QuickConnectors
tm
(Fig 10) are available in straight, 90 deg, and ¼” flare
configurations and are ideal for this application. See our web site for more details.
Warning!
Always securely fasten the hoses to the product with hose clamps to prevent a hose from
slipping off during use and possibly causing severe burns!
Note that the mating fittings are NOT included with the product! Each brewer prefers their own hose
size and fitting type for their brewery and intended application so we have not included these parts.
Important!
The location of the HopRocket
tm
in your installation is very important. Please note that the
BOTTOM is the INLET of the HopRocket
tm
and the TOP is the OUTLET of the unit. Connecting it the
opposite way will cause an airlock and the product will not function properly! The product label has
arrows showing the direction of flow. The outlet fitting is located on the top of the canister to allow the
air to naturally purge from it.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
