Installing the Therminator™
Mount the Quick Release plate to the table using the hardware provided. Make sure to use 2 washers
between the bracket and table on each hole to give enough clearance. (Fig. 10)
There will be 1 or 2 cable pass-through holes in the back of the table to run the controller cords through. If
you are using the Dual Element Controller it is possible for all four cables to fit through a single grommet.
Step 1:
Remove Grommet
Step 2:
One cable at a time, route cables through the table and grommet.
Step 3:
Re-install grommet into table. (See images below.)
Installing the Temperature Controllers
5
3
4
2
1
4
Fig. 10
Use thread tape on all male threads except when using QuickConnectors.
Thread Sealing Tape
2 washers
*Pictures shown for 55 gallon
systems only . All other systems will
have 2 cables running through the
grommet.
