4
Power On
Push and hold the “Power” button for at least 2 seconds to
power on. The Blue LED turns on and you will hear ascending
beeps an “Power on”
Power off
Push the “Power” and “Phone” buttons at the same time for 2
seconds, the red Led turns on for about 1 second untili t turns
off completely and you will hear “Power off”.
Pairing with Phone
Please make sure the Blinc-A2 is in power off position. Push the
“Power” button for at least 5 seconds till the LED flashes in red
and blue alternately and you will hear a voice prompt saying
“Pairing” in the speakers. Enable your Bluetooth function on
your mobile phone. Your mobile phone will now scan nearby
devices and find a device named “BLUETOOTH HELMET”. Please
allow your mobile phone to pair with the device. When pairing
has completed and the Blinc-A2 is ready for use you will hear a
voice prompt saying “Pairing succesfull” in the speakers.
Once pairing between the two devices is succesfull, the LED
lights on the Blinc-A2 will change from red and blue flashing
lights to a blue LED light only.
Note: if a PIN codes is required by your mobile phone, please
enter “0000”.
If you paired with your phone and Blinc-A2, Blinc-A2 will
connect your phone automatically when you turn it on again.
Pairing with a second Bluetooth device or mobile phone
Multipoint Bluetooth pairing allows the Blinc-A2 to connect
two Bluetooth devices at the same time.
You can pair the first and second Bluetooth device or mobile
phone to the Blinc-A2 by following the simple procedures in
“Pairing with your mobile phone”.
After second Bluetooth device or mobile phone confirms that
EN
