7
working in 5 seconds if the sound is low, and when you’ll speak
again, the microphone also will working again.
Pair with BL300
Press “Phone” button about 7 seconds until blue LED stop
lighting in stand-by mode. Then operate ET300 complete
pairing.
Remote control with BL300
Press the grey button (Music button) to play music in your
mobile phone if there no music palying. Push the grey music
button again to pause the music.
Double click the green button when Blinc-A2 in stand-by mode
that will start the voice call. When there is an incoming call, you
can press green button to answer the call.
Double click the green button to reject an incoming call.
Press the green button to terminate the call when calling.
Press the green button to establish the intercom when Blinc-A2
is in stand-by mode, and press again to terminate the intercom.
If you paired the Blinc-A2 with ET200, when you press the RED
button, the walkie talkie will be into sending state. After you
release it, the walkie talkie will be into receiving state.
Press button to track forward song; long press this
button to increase the volume Press Volume- button to track
back song; long press this button to decrease the volume.
Voice prompt indicator for battery capacity
When you power off the headset, simply press the “Power”
button for 1 second, then you will hear a voice prompt
indicating the battery level:
“Battery full”: 70/100 %
“Battery fifty percent”: 30/70%
“Battery low”: 0/30%
Low battery warning
When the battery is low, the red LED will blink for every 30
EN
