7
M o u n t i n g a n d i n s t a l l a t i o n
Your new Blitz Series crossover comes complete with all required mounting
hardware.
Mark the location for the mounting screw holes by positioning the crossover
where you wish to install it and use a scribe (or one of the mounting screws)
inserted in each of the mounting holes to mark the mounting surface. If the
mounting surface is carpeted, measure the hole centers and mark with a felt
tip pen.
Before attempting to drill the mounting holes, take note of any wires, lines or
other devices in your vehicle which may be located behind the mounting surface!
Then drill pilot in the mounting surface for the mounting screws and insert
then. Tighten the screws securely.
BTS-1 4
ø
x12N x 4
SW 4
ø
(B) x 4
PW 4
ø
(B) x 4
All manuals and user guides at all-guides.com
