Your new Blitz Series amplifier comes complete with all required mounting hardware.
Mark the location for the mounting screw holes by positioning the Line Driver where
you wish to install it and use a scribe (or one of the mounting screws) inserted in each
of the mounting holes to mark the mounting surface. If the mounting surface is carpeted,
measure the hole centers and mark with a felt tip pen.
Before attempting to drill the mounting holes, take note of any wires, lines or other
devices in your vehicle which may be located behind the mounting surface! Then drill
pilot in the mounting surface for the mounting screws and insert then. Tighten the
screws securely.
7
M o u n t i n g a n d i n s t a l l a t i o n
