5
f e a t u r e s a n d s p e c i f i c a t i o n s
Frequency response
Variable Q. control
Variable boost frequency
Input impedance
Maximum output
S/N ratio
Channel separation
THD
Power supply
Dimensions
20Hz-400Hz
2-20
40Hz-400Hz
10K Ohm
7 Volts
>90dB
60dB
0.07%
10-16V DC, negative ground
1.8"H x 7.9"W x 4.8"D
1. INPUT LEVEL CONTROL
2. LED POWER ON INDICATOR
3. LED CLIPPING DETECTOR
4. LOW LEVEL INPUT PORT
5. SUBWOOFER OUTPUT PORT
6. SUBWOOFER SELECTABLE PHASE
SHIFTER
7. SUBWOOFER STEREO/MONO SELECTOR
8. POWER TERMINALS
Turning this control to adjust the input sensitivity of the set to match the radio's output.
The LED indicator lights up when the internal switching power supply is activated and the unit
is operational.
This indicator lights up to indicate the output voltage reaches or surpasses 7 volts RMS
maximum out for the remote level control output.
Low level input RCA jacks used to connect to the output of the signal source
RCA jacks used to connect to the bass amplifier line inputs.
Allows you to change the phase of your subwoofer 0 or 180 degrees to help compensate for
timing differences between drivers.
For selection of stereo or mono mode subwoofer output.
Use these connectors to deliver power, ground and remote turn-on control to the unit.
REMOTE CONTROL UNIT
1 Q SELECT
This control will narrow or widen the boost frequency bandwidth (Q=factor) being
sent to the amplifier for each band from Q=20(Narrow bandwidth, steep slope) to
Q=2 (Wide bandwidth, gentle slopes).
2 BASS FREQUENCY
This control sets the center frequency of the bass boost effect from 40Hz to 400Hz.
3 SUBWOOFER LEVEL CONTROL
This control sets the subwoofer level control.
