Operating Instructions for Suspended Jacks
11
Transversely adjustable undercarriage
Transverse and height-adjustable
undercarriage
B
A
A
Insert undercarriage in rails and set track
width.
Check the secure support of the castors
(standard castors min. 25 mm) over the entire
length of the rails.
Secure the undercarriage width with screws A
(2 pcs. per side) to 30 Nm.
Screw side plates to desired height on the
undercarriage.
Tighten all screws B with a torque wrench to
80 Nm.
Insert undercarriage in rails and set track
width.
Check the secure support of the castors over
the entire length of the rails.
Secure the undercarriage width with screws A
(2 pcs. per side) to 30 Nm.
Transversely adjustable undercarriage
Lift the jack into the undercarriage and lower
it (A) until the operating element [2] is just
below the guide rails
Turn the jack 90° (B)
Set jack down on the undercarriage
A
B
