Page
4
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to your retailer.
Fault
Probable Cause
Action
The appliance is not working
The unit is not switch on
Check the unit is plugged in correctly and switched on
Plug and lead are damaged
Call your agent or qualified technician
Fuse in the plug has blown
Replace the fuse
Power supply
Check power supply
Internal wiring fault
Call your agent or qualified technician
The appliance turns on, but
the temperature is too
high/low
Too much ice on the evaporator
Defrost the appliance
Condenser blocked with dust
Call your agent or qualified technician
The appliance turns on, but
the temperature is too
high/low
Doors are not shut properly
Check doors are shut and seals are not damaged
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Move the refrigerator to a more suitable location
Ambient temperature is too high
Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored in
the appliance
Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded
Reduce the amount of food stored in the appliance
The appliance is leaking
water
The appliance is not properly levelled
Adjust the screw feet to level the appliance(If applicable)
The discharge outside is blocked
Clear the discharge outlet
Movement of water to the drain is
obstructed
Clear the floor of the appliance (if applicable)
The water container is damaged
Call your agent or qualified technician
The appliance is unusually
loud
Loose nut/screw
Check and tighten all nuts and screws
The appliance has not been installed in a
level or stable position
Check installation position and change if necessary
Technical Specifications
Model
Voltage
Gas
type
Power
(W)
Current
(A)
Temperature
Range(
℃
)
Capacity
(litres)
Dimensions
HxWxD(mm)
Weight
(kg)
BR1SS
220
～
240V/50Hz
R290
215
1.4
-2
～
+8
650
2010x740x830
121
BF1SS
220
～
240V/50Hz
R290
480
3.2
-18
～
-22
650
2010x740x830
126
BR2SS
220
～
240V/50Hz
R290
440
2.6
-2
～
+8
1300
2010x1480x830
188
BF2SS
220
～
240V/50Hz
R290
780
5
-18
～
-22
1300
2010x1480x830
201
Electrical Wiring
Appliances are supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard. The plug is to be
connected to a suitable mains socket. Appliances are wired as follows:
Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green) to terminal marked E
All appliances must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being
required they must be readily accessible.
Pentland Wholesale Ltd, Blizzard house, Unit17 Walker Park Industrial Estate, Walker Road, Blackburn,
