4
Operation
*
Before first use, clean the inner sides and the playing grids with a soft cloth and a mild cleaning agent.
Afterwards,
dry
the device thoroughly.
*
Remove the water bowl from the device. The water bowl is installed inside the device and then fill the
water bowl with water
.
*
Connect the device to a single grounded power socket.
*
Set the temperature as required for respective foods. You may adjust the desired temperature in the range
between 30
'
C-90
'
C
.
*
The temperature inside of the hot display can be read from the front display.
*
Put the foods in appropriate containers before playing them inside the hot display and shut it by using the
sliding door
.
*
Some of the device parts become very hot, always use safety gloves when placing or removing foods
.
*
The foods are kept warm at the temperature set by you previously
.
*
In
order to place or remove foods, you may open the door at rear side.
*
Switch on the inner light when required using the light switch of the device.
*
Disconnect the device from the power socket when the device is not in use.
Cleaning and Maintenance
*
Before beginning with repair or cleaning works make sure the device has been disconnected from the
power socket and has cooled down
.
*
Don't use any acid agents and make sure no water ingresses the device
.
*
To protected yourself from the electric shock, never immerse the device, its cables and the plug in water
or other liquids
.
*
Don't use any kind of pressure water jet for cleaning the device.
Cleaning
*
The device should be cleaned regularly
.
*
Clean the device from the inside and outside with a soft
,
damp cloth and a mild cleaning agent.
*
Clean the placing grids and the housing with a soft, damp cloth and a mild cleaning agent.
*
Clean the water bowl regularly
.
Calcifications at the water bowl may be removed with common agents or
liquids
.
*
Only use a soft cloth and make sure you never use any kind of abrasive agents or pads which could
scratch the surface.
*
After the cleaning procedure, you should use a soft and
dry
cloth to wipe
dry
and polish the surface.
*
Make sure the device has been cleaned properly before storing it in a
dry
place
.
Maintenance
*
Check the mains lead from time to time to ensure it is not damaged in any way. Never use the device if
the lead
is
damaged
.
If
the lead is damaged, it must be replaced by a qualified electrician.
