x4
2
#MADEINBELFAST
10.0031
10.0019
30
Nm
DRILL HOLE
VACUUM
HAMMER IN
BOLT
TIGHTEN
90MM
SLEEVE ANCHOR BOLT FITTING
-DRILL 10MM HOLE IN WALL, 90MM DEEP USING
PLATE AS A GUIDE.
-VACUUM OUT THE DUST.
-HAMMER SLEEVE ANCHOR INTO THE HOLE.
-TIGHTEN SLEEVE ANCHOR TO SPECIFIED TORQUE
USING 13MM SPANNER.
BOLT 1QTY WALL BALL TARGET (21-0224-0A) TO THE WALL USING 4QTY SLEEVE ANCHOR
BOLTS (10-0031) AND 4QTY M10 WASHERS (10-0019) DRILL HOLES AND MOUNT USING
GUIDE AS SHOWN BELOW, TIGHTEN TO SPECIFIED TORQUE.
