Block A 100, Instruction Manual

BATTERY INSTALLATION

By using the provided remote control unit the A 100  can be 
controlled from your listening position. To use the remote
control unit, point it at the REMOTE SENSOR window of the 
receiver.

Notes:
-Even if the remote control unit is operated within the 
effective range, remote control operation may be impossible if 
there are any obstacles between the unit and the remote 
control.
-If the remote control unit is operated near other appliance
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may 
operate incorrectly.

Precautions concerning batteries
-Be sure to insert the batteries with correct p and
 negative - polarities.
-Use batteries of the same type. Never use different types of
batteries together.
- Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
-When the remote control unit is not to be used for a long 
time(more than a month), remove the batteries from the 
remote control unit to prevent them from leaking. If the leak,
wipe away the liquid inside the battery compartment and 
replace the batteries with new ones.
-Do not heat or disassemble batteries and never dispose of 
old batteries by throwing them in a fire.

REMOTE CONTROL OPERATION RANGE

Use the remote control unit within a range of about 7
 meters and the angles of up to 30 degrees aiming at
 the remote sensor.  

1.  Remove the battery compartment cover.

2.  Insert two "AAA" dry batteries.

Make sure that the batteries are inserted with their

positive "+" and negative "-" poles positioned correctly.

3. Close the cover until it clicks.

If the distance required between the remote control unit and

main unit decreases, the batteries are exhausted. In this case,

replace the batteries with new one.

REMOTE  CONTROL  

This part for C 100

P14

CD

STANDBY

RADIO

STANDBY

AMP

STANDBY

SPK A/B

SPK A+B

IR100

INFO

MEMORY

P-MODE

F-SCAN

STEREO

MONO

AM

PR+

PR-

FM

INFO

R100

AUTO+

AUTO-

(FUNCTION)

(INPUT)

1

2
3

4

5
6

1

.

If the unit is A 100 power amplifier,

press to change output speaker

    mode.  With 2 modes for  selection,
    Speaker A  and Speaker B.
    
    If the unit is V 100 amplifier, 
    press to  go to menu  features such  as bass, 
    treble,   balance, reset,   and use
    VOL-/+ key to adjust the parameter.
  
2. Standby key

3.  If the unit is A 100 power amplifier,
     press to change output speaker mode
     to Speaker A+B. 

     If the unit is V 100 amplifier,
     press to change input source.
4. Volume level down key 
   (for model P 100 and V 100)

5. Volume level up key 
   (for model P 100 and V 100)

6. Mute key

This part for R 100

This part for IR 100