Maintenance
26
Deliming
WARNING!!
Deliming solutions are hazardous and
can cause burns to the skin and eyes.
Wear protective clothing and eyewear
when decalcifying your appliance.
Deliming of the steam generator is the single most
important preventative maintenance task. Lime
will build up inside the steam generator, reducing
efficiency and causing damage to the level control
system.
WARNING!!
Problems caused by insufficient deliming
are not covered by the warranty.
This oven comes equipped with a Delime lamp to
indicate when the steam generator needs to be
delimed. The Delime lamp will flash when the
steam generator has been run for the preset inter-
val. The flashing Delime lamp does not impede the
operation of the oven, as you can use the oven
normally when the lap is flashing. You may choose
the best time to start the deliming process.
NOTE: To further prevent buildup of scale, this
oven will automatically drain the steam
generator after 5 hours of being in the off
mode.
WARNING!!
If the oven is hot, it must be placed in the
cool down mode for 1 minute with the
door open prior to starting the deliming
process. Once the process has been
started, the oven cannot be used until the
process is complete. The total process
time is approximately 45 minutes.
DELIMING WITH DELIMING PUMP
NOTE: The Delime lamp must be flashing to start
this process.
1.
Be sure the container delivering the deliming
agent to the appliance is full.
2.
Be sure the door is open.
3.
Turn the oven into
Cool Down
mode. Press
and release the
On Demand Steam
button.
The Delime lamp will flash faster, acknowledg-
ing the action.
4.
Turn the oven to the OFF mode.
5.
The remainder of the procedure is automatic.
The Delime lamp will stay illuminated while the
process is active. When the process is com-
pleted, the Delime lamp will turn off indicating
the appliance can now be used normally.